"fatbaby" By Project Sub-Ohm™
Even since the introduction of the "littlemaN'™ Box mod, the "littlemaN"™ has gain a huge popularity among the world of vapers! Now Project Sub-Ohm™ has found a perfect platform to build on its third box mod. The "fatbaby"™ 100 Watts Mod made by Project Sub-Ohm. The goal is simple, to create an affordable yet still super powerful device that can satisfy majority of the vapers out there!
- 1 x "fatbaby"™ Mod by Project Sub-Ohm™
- 1 x screwdriver
- 4 x copper center pins
- 4 x stainless steel screws for back battery door
- 1 x instruction manuel
- 1 x signature "fatbaby" Mod gift box with Project Sub-Ohm™ and 'fatbaby"™ logo
The "fatbaby"™ series by Project Sub-Ohm™ is a powerful Variable Wattage Device that can adjustable it's power from 10W to 100W in increments of 0.1 Watts! This device uses upgrade YiHi SX330 Chip, which is capable of firing coils at 0.15 ohm up to 3.0 ohm. The "fatbaby"™ Mod is powered by a dual IMR 18650 battery and is capable of producing up to 100 Watts of power! The two screws on the back of the device hold the battery cover firm and sturdy, additional two magnets are in installed as well to hold the back battery cover without the use of the screws for ease of swapping batteries. The battery is removable, so changing batteries are a breathe to do. The OLED screen is bright and easy to read, and also shows you the wattage, resistance, output voltage and battery life.
- Beauty screen and greeted with "fatbaby"™ when turned on
- Full Aluminum Body For rigidity!
- Capable of firing 0.2 ohm - 3.0 ohm build
- Capable of putting out 100 Watts of power!
- Beautifully Engraved With Project Sub-Ohm™ Logo and "fatbaby"™ logo
- Serialized (Roman Numeral Serialization, I, II, III and so on)
- Roman Numeral Serialization is an extremely labor intensive work, each number is manually adjustable with live people!
- Matches all other Project Sub-Ohm™ products
- We Made It Powerful! We Made it Affordable!
- Unique and Elegant "fatbaby"™ gift box packaging. (Highly Sought After!)
- Output Power: 10W - 100W
- Output Voltage: 1.5V - 7.0V
- Loading Resistance: 0.15 ohm - 3.0 ohm
- Output Short Circuit Protection
- Reverse Battery Protection
- Dimension: 102mm x 56mm x 23mm (2-3/16" x 4" x 7/8")
- FOR USE WITH 30 AMPS OR HIGHER IMR BATTERIES ONLY!
- Please do not put in your battery in wrong direction
- Make sure battery sit completely snug in the battery slot
- Do not use any batteries if the outside wrapper has come off!
- Turn off the device before pulling your battery out
- Do not wrap your coils below recommanded ohm level and always vape safe!
- 510 pins are reverse threaded, do not force it pin does not turn
- Alway turn off the device and take the batteries out when not in use!
- Center pin is reverse threaded, do not force turning! (Screw right for pin to up, screw left for pin to go down)
WHERE: >> HERE <<
USE COUPON CODE JOE5 TO TAKE $5.00 OFF THIS PURCHASE.